Your present location:Home -> LPPM

Low Pressure Permanent Mold 


               Low Pressure Permanent Mold Casting is a casting process that uses a reusable mold. Metal is injected at low pressures (20 –60 kPA) into the bottom of the mold and soon after, the metal solidifies. The process provides good surface finishes, good dimensional accuracy and minimizes porosity formation. This has advantages over sand castings and gravity castings for large shapes. Seagull uses the most advanced imported brass casting equipment and technology in the world. The process is automated with Program Logic Controllers (PLC). The process uses less labor, less energy and has low environmental pollution.




Tel:+86 20 8489 6096 Fax:+86 20 8489 3787

 Copyright © 2015 Seagull 粤ICP备11029471号